Contact Us

If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.

Please fill out the contact form below and we will reply as soon as possible.

  • Knowledge Base Home
  • Contact Us
  • Home
  • Moku:Lab
  • Moku:Lab general
  • Using Moku:Lab

How to connect my Moku:Lab to a Windows PC through direct Ethernet cable

Written by Paul Cracknell

Updated at March 25th, 2021

Contact Us

If you still have questions or prefer to get help directly from an agent, please submit a request.
We’ll get back to you as soon as possible.

Please fill out the contact form below and we will reply as soon as possible.

  • Moku:Go
    Moku:Go Arbitrary Waveform Generator Moku:Go Data Logger Moku:Go Frequency Response Analyzer Moku:Go Logic Analyzer & Pattern Generator Moku:Go Oscilloscope & Voltmeter Moku:Go PID Controller Moku:Go Spectrum Analyzer Moku:Go Waveform Generator Moku:Go Power Supplies Moku:Go Digital Filter Box Moku:Go FIR Filter Builder Moku:Go Lock-in Amplifier
  • Moku:Lab
    Windows Moku:Lab general Moku:Lab Instruments iPad app Software integrations
  • Moku:Pro
    Moku:Pro Instruments
+ More

Direct Ethernet connection without a router or switch

To connect your Moku:Lab to a Windows PC through Ethernet cable without a router or a switch, you will need to configure the network and assign the Moku:Lab a static IP address.

Configuring the PC network:

  1. In your PC go into "Settings" -> "Network & Internet" -> "Ethernet"
  2. Select "change network properties" and "Edit IPv4 settings" 
  3. Configure the IPv4 setting as shown below:

Note: depending on the version of Windows operating system that you are using, you may be required to set the subnet prefix length, set this to 24.

Fixing the IP of Moku:
  1. Use the iPad to connect to the Moku through Wifi
  2. In "Select your device" menu, tap on your Moku, then tap the settings icon on the bottom left corner, this will open the "Device settings" menu
  3. In the "Device settings" menu, tap on Ethernet, switch on "Connect via Ethernet"
  4. Set "Configuration" to Manual, then set IP address to 192.168.1.167 with subnet mask 255.255.255.0
  5. Tap "Apply" 
You should now be able to connect to your Moku through the Ethernet cable using the IP address of 192.168.1.167.
moku:lab

Was this article helpful?

Yes
No

Related Articles

  • Do you need internet access to use your Moku?
  • Remote access to Moku:Lab data logs
  • How do I locate my Moku in a lab with many Mokus?
  • Can I disable firmware updates ?

Sitemap

  • Moku:Lab
  • Instruments
  • Software
  • Company
  • Support
  • Store
  • Terms & Conditions
  • Privacy Policy

Offices

United States
+1 (619) 332-6230
740 Lomas Santa Fe Dr
Suite 102
Solana Beach, CA 92075

Australia
+61 2 6171 9730
243 Northbourne Avenue
Suite 2
Lyneham, ACT 2602

Follow us

Youtube LinkedIn

官方微信

Contact us
© 2021 Liquid Instruments. All rights reserved.

Definition by Author

0
0
Expand