Liquid Instruments Knowledge Base

Dylan Perez

dylan@liquidinstruments.com

Article
Last Month

2000.0%

Dylan articles

All Categories

All Categories
Moku:Go
Moku:Lab
Moku:Pro
Python API
MATLAB API
Arbitrary Waveform Generator
Data Logger
Digital Filter Box
FIR Filter Builder
Frequency Response Analyzer
Laser Lock Box
Lock-in Amplifier
Oscilloscope
Phasemeter
PID Controller
Spectrum Analyzer
Time & Frequency Analyzer
Waveform Generator
Logic Analyzer & Pattern Generator
Multi Instrument Mode
Moku Cloud Compile
Moku general
LabVIEW

Can Moku be used with Raspberry Pi?

Published April 8th, 2025 by Dylan Perez

While the Moku software and mokucli are not currently available for ARM processors, it is possible to use API commands to control your Moku. To install the Moku Python API onto the Raspberry Pi, first open up a terminal and run python -m pip install moku and wait for that to complete. Then, run moku download --fw_ver=601 (replace 601 with the

Connecting to Moku via API Using Serial Number

Published January 23rd, 2025 by Dylan Perez

Using the Moku API to connect to and configure your Moku is straightforward and well documented on our API documentation site (https://apis.liquidinstruments.com). Typically, users will opt to use the IPv4 or IPv6 address of the Moku to point to the device to connect to in the script. ## This is an example of connecting to Moku using the IPv4 addre

How to convert voltage units to phase units from the Lock-In Amplifier

Published April 8th, 2025 by Dylan Perez

Liquid Instrument's Lock-In Amplifier (LIA) can recover amplitude and phase information from a low signal-to-noise ratio (SNR) signal. The LIA can recover the in-phase (X) adn quadrature (Y) component of your signal, or can be switched to polar mode which will output the amplitude (R) and phase ( Θ) of your signal. When the LIA is set to Θ mode, the

Dynamic Amplitude Adjustment

Published December 13th, 2024 by Dylan Perez

The Dynamic amplitude setting in the Frequency Response Analyzer is a powerful tool that allows you to get the most accurate frequency response of your device under test (DUT). When using the frequency response analyzer, the signal going to your DUT should usually have the largest amplitude possible to ensure that you have a high resolution curve. H

Contact Us

Dylan Perez

Can Moku be used with Raspberry Pi?

Published April 8th, 2025 by Dylan Perez

Connecting to Moku via API Using Serial Number

Published January 23rd, 2025 by Dylan Perez

How to convert voltage units to phase units from the Lock-In Amplifier

Published April 8th, 2025 by Dylan Perez

Dynamic Amplitude Adjustment

Published December 13th, 2024 by Dylan Perez