Knowledge Base
Moku:Lab Instruments
Moku:Lab Instruments
Arbitrary Waveform Generator
Data Logger
Digital Filter Box
FIR Filter Builder
Frequency Response Analyzer
Laser Lock Box
Lock-in Amplifier
Oscilloscope
Phasemeter
PID Controller
Spectrum Analyzer
Waveform Generator
Moku:Lab general
Getting Started with Moku:Lab
Using Moku:Lab
Hardware
iPad app
Windows
Software integrations
Python
Python examples
MATLAB
MATLAB examples
LabVIEW
Back to home
Knowledge Base
Moku:Lab Instruments
Moku:Lab Instruments
Arbitrary Waveform Generator
Data Logger
Digital Filter Box
FIR Filter Builder
Frequency Response Analyzer
Laser Lock Box
Lock-in Amplifier
Oscilloscope
Phasemeter
PID Controller
Spectrum Analyzer
Waveform Generator
Moku:Lab general
Getting Started with Moku:Lab
Using Moku:Lab
Hardware
iPad app
Windows
Software integrations
Python
Python examples
MATLAB
MATLAB examples
LabVIEW
Moku:Lab Instruments
Individual instrument knowledge
How does the control matrix work?
Arbitrary Waveform Generator
What file formats does the Moku:Lab Arbitrary Waveform Generator support
Can the Arbitrary Waveform Generator be triggered?
How can I upload custom waveforms from my iPad?
What file formats are supported for data logging?
Data Logger
For how long can the Data Logger record ?
How can I read data from .li files?
How can I import a .CSV file from Moku:Lab’s Data Logger into MATLAB?
Digital Filter Box
Can I load my own filter coefficients?
How are the IIR filters implemented?
FIR Filter Builder
Can I load my own FIR filter coefficients?
Can Moku:Lab also create IIR filters?
Frequency Response Analyzer
Using the Frequency Response analyzer to measure inductance
How can I plot the ratio of input 1 and input 2?
How is the magnitude in dBm calculated in Moku:Lab’s Frequency Response Analyzer?
Laser Lock Box
If Moku:Lab only has two output channels, how is it possible to generate feedback control signals as well as the modulation tone and scanning waveform?
Can I adjust the corner frequency of the low-pass filter?
What laser locking techniques does the Laser Lock Box support?
Does it lock continuous wave and pulsed lasers?
What if my actuator can't take negative voltages?
Moku:Lab's Laser Lock Box : When and how should I use the slow PID controller?
See more
Lock-in Amplifier
How does Moku:Lab's Lock-in Amplifier measure small signals with 12-bit ADCs?
Can Moku:Lab's Lock-in Amplifier output a signal to drive a modulator?
Can I adjust the corner frequency of the low-pass filter?
What is the maximum rate at which I can save data, and how many points can I save?
Can the Lock-in Amplifier demodulate using an external source?
Does the Lock-in Amplifier include a PID controller for feedback applications?
The Lock-in Amplifier can readout I and Q (X and Y). What about R and theta?
See more
Oscilloscope
Can I set the channel offset in screen divisions while zooming?
What is the difference between "Normal" and "Precision" acquisition modes?
What are the definitions of the Oscilloscope's measurements?
What measurements can the Oscilloscope make?
What is timebase setting "roll"?
See more
Phasemeter
Phasemeter output waveform resolution
How does Moku:Lab calculate Allan Deviation?
Can I measure the phase or frequency difference between the two input channels?
How does Moku:Lab calculate the Power Spectral Density?
What reference does the Phasemeter measure against?
How to remove drift in Phasemeter measurement
See more
PID Controller
What is the closed-loop bandwidth of the PID?
What do the different colored buttons mean when configuring a PID controller?
How can I invert my controller's response?
Spectrum Analyzer
What's the difference between the spectrum analyzer and oscilloscope FFT?
How do I generate waveforms on Moku:Lab’s analog outputs while running the Spectrum Analyzer?
How do I track a peak?
Waveform Generator
Can you generate a chirp with Moku:Lab's waveform generator?
Waveform Generator: What are my options for triggered burst mode?
What is the triggered sweep mode?
